Antistatic Esd Pad Mat in rolls
1. ESD pad mat technical data
2.Anti-static pad mat for floor laying
1. Putting xylene in the washing machine will clean the ground with anti-static mats, and lay the copper bars or aluminum strips on the ground according to the requirements of the ground laying. In this process, in order to To allow static electricity to be introduced into the ground, it is necessary to bring one end of the copper strip or aluminum strip to the ground.
2. After the copper strip or aluminum strip is laid, clean the floor and dry it and apply the glue.
3. Wait for about half an hour. When the glue is not sticky, bond the anti-static mat to the ground. Roll or beat with a roller or a small hammer to make the surfaces of the two straight. After 2 days of installation, Can be used with confidence.
3.What kind of environment does the esd pad mat use?
4. Our Qualification for esd pad mat
5.Applications
Anti-static mats are suitable for use in the production workshops and advanced laboratories of microelectronics industries such as electronic semiconductor devices, electronic computers, electronic communication equipment and integrated circuits. In order to reduce or eliminate the danger of static electricity, it is necessary to lay anti-static mats or conductive grounds. Pad, when the anti-static mat is laid and grounded, the working surface will discharge the static electricity of the human body, so that the ESD tweezers, tools, instruments, instruments, etc. that the human body is in contact with the table surface reach a substantially uniform potential, which makes the electrostatic sensitive device (SSD) It is immune to the interference of the wide step belt caused by the discharge phenomenon such as frictional electrification, thereby achieving the effect of electrostatic protection.
6.Our Payment Terms:
Paypal, T/T ,Western Union, Also accept monthly closing.
7.. What are the requirements for using anti-static mats?
The anti-static workbench mainly uses anti-static mats on the workbench to solve the electrostatic hazard. The anti-static mats must meet the following requirements:
1. The size of the anti-static table mat should not be less than the size of the work surface.
2. The anti-static mat must have the front (ie green anti-static surface) facing up and the back (ie black conductive surface) facing down.
3. The anti-static table mat is connected to the common grounding point of the anti-static workbench, and then the grounding point of the workbench is directly connected to the grounding busbar for grounding. Each anti-static mat must be connected with only one anti-static grounding wire. The grounding wires of the anti-static workbench cannot be connected in series with each other and should be connected in parallel with the grounding busbar.
4. When pressing the anti-static grounding buckle of the anti-static mat, press it from the front of the anti-static mat to pass it through the mat and tighten it to ensure good contact.
5. The surface resistance between any two points on the anti-static mat is between 10 and 9 to the power of 10, the resistance of the bottom is between 3 and 5, and the discharge of static electricity is less than 100V. Less than 1 second, if it does not meet the need to replace it in time.
6. When an insulating oil film, resin and other contaminants are attached to the antistatic table mat, it should be cleaned with a neutral detergent or antistatic agent in time.
8.Packing & Shipping
Hot Tags: ESD pad mat, China, suppliers, wholesale, cheap, price
