Anti-static rubber floor mat laying method in machine room

Jun 11, 2019 Leave a message

                                    Anti-static rubber floor mat laying method in machine room


Basic ground requirements


1. The foundation ground can be a cement floor with a smooth surface, a terrazzo floor, a tile floor, and a wooden floor.



2, the ground must be flat, no obvious unevenness, the unevenness should be less than two thousandths


3, the ground has sufficient strength, no sanding, shelling phenomenon.


4. The ground must be dry.


Construction procedures and specific methods

1. Wash the waste on the ground with cleaning solution or xylene (with washing machine)


2. The thickness of the copper strip for grounding conductive grid laying is 0.02mm and the width is 20mm. The number of strips is determined according to the actual width requirement of the ground. The direction of the copper strip is perpendicular to the direction of the anti-static mat, and the strip is 2-3m apart. ), at the same time, the end of the laying copper strip is led to the outdoor grounding pole of the earth.

3. After the grounding conductive mesh is laid, put the anti-static rubber mat on the ground in turn. If the gap between the rubber mats is too large, the knife can be straightened to make the gap smaller. Turn the edge of the laid anti-static rubber mat on the floor mat (about 500px), apply glue (401 glue or double-sided tape) in the middle of the gap, and dry for 20-30 minutes, so that the hands are not sticky. The tape can be glued immediately. The bottom surface of the anti-static mat (black surface) is the same (smooth glue can be applied once evenly, double-sided tape can be applied to the ground, anti-static mat does not need to stick double-sided tape on the bottom), then Bond the anti-static mat to the ground, and then roll it with a heavy roller several times to make the surface of the anti-static mat neat and straight (if there is heavy roller rolling by hand or by foot), at room temperature It can be used after 48 hours.