Do anti-static rubber pads need to be installed with pressure strips?
When the anti-static rubber pad is laid as a floor mat, the thickness is generally 3mm and above, and the weight per square meter is generally not less than 4.5kg, so the weight of the anti-static rubber pad itself is sufficient to ensure that it will not appear when people are walking. Drumming and other phenomena, but the premise is that the edge of the anti-static rubber pad will not be kicked inward.
I have never encountered such a situation. Due to the laying requirements, the anti-static rubber pad cannot completely cover the entire room, so there will be a certain gap between the edge of the anti-static rubber pad and the surrounding ground, and people will inevitably kick when walking. To the edge of the anti-static rubber pad, after such a long time, it is difficult to ensure that the anti-static rubber pad will not drum up. Therefore, if the entire room cannot be covered due to actual requirements during laying, it is recommended to install pressure strips on the edge of the anti-static rubber pad. At the same time, it is better to use anti-static glue before laying to enhance the bonding strength of the anti-static rubber pad and the ground.