Electrostatic Discharge Causes Combustion and Explosion Hazards
After an object is charged with static electricity, it must always be discharged. There are two ways to discharge the charge: one is natural dissipation; the other is different forms of discharge. Electrostatic discharge is the process of converting electrical energy into mature energy, which may ignite combustibles and become a source of fire or explosion. Therefore, anti-static is very important in the process of production, transportation, and installation. Reasonable selection of anti-static workbenches, anti-static packaging, and anti-static operating tools are closely related to safe production.
For electrostatic discharge to become an ignition source, the following conditions must be met at the same time:


1. There is a source of static electricity;
2. Static electricity can be accumulated, and its electrostatic voltage is sufficient to cause electrostatic discharge;
3. The energy of the electrostatic discharge is sufficient to ignite the flammable mixture:
4. The discharge must occur within the explosive concentration range of the explosive mixture.
I can see from the above conditions that only when the four basic conditions are met at the same time can ignition occur. From the perspective of eliminating electrostatic hazards, as long as any one of the conditions is destroyed, the purpose of preventing ignition can be achieved.
Safe margins for static buildup
1. The safety limit of static electricity accumulation in the conductor
When the charged object is a conductor, it is generally considered that the most dangerous situation is that an electrostatic discharge can release almost all the stored electrostatic energy, and when the electrostatic energy stored in the charged conductor is equal to or greater than the minimum ignition energy (or electrostatic sensitivity), there will be Risk of electrostatic hazard accidents.
2. The safe limit of electrostatic accumulation of insulators
When the charged object is insulated, if a discharge occurs, generally the charged object will not release all the accumulated electrostatic energy, but partly release it. Therefore, if the charged object is an insulator, the discharge safety limit cannot be obtained by the method used by the charged conductor, which depends on the discharge conditions and discharge type, and is also related to the charged potential of the electrostatic non-conductor and the radius of curvature of the grounded conductor.

