Material composition and usage of dust removal mat
The dust removal pad is composed of multiple layers of polyethylene film, each layer is attached with a high-viscosity coating, which is smooth and durable, and can quickly and effectively remove dirt and dust on the soles of the shoes and keep the working environment clean.
When using the dust removal mat, first tear off the protective layer of the rubber surface from the opening on the back, and then place it flat on a clean and water-free access floor, and use the sole to flatten the dust removal mat on the ground, and then from the front Tear off the protective layer at the opening of the device so that it can be used.
If the surface of the film is covered with dust during use, remove this layer from the opening so that the next clean film can be used. The dust-removing mat is made of a piece that has been treated and has no gas leakage, and is highly viscous. It is used for dust removal of shoes in the aisle of clean rooms and areas with purification requirements.
The laminated polyethylene film has a special pressure or stickiness on one side. When a person walks on it or a wheel runs over it, the dust removal pad will stick to any dirt attached to the heel bottom or even the wheel. When the mucous membrane of a dusting pad is full of dirt, it is peeled off and a new layer of mucous membrane is used, so there is no need to clean and wash. The dust removal mat is non-slip and pollution-free, and will not be damaged by shoes or wheels. Each layer has the same size, and there will be no defects or pollution caused by gaps. The remaining amount is marked on the corners of the dust removal mat, which is easy to tear off the contaminated layer after use.