Static elimination and protection measures in LED production process

Mar 19, 2019 Leave a message

Static elimination and protection measures in LED production process


Before introducing the static elimination and protection measures in the LED production process, what is the LED? LED English abbreviation, the main meaning: LED = Light Emitting Diode, LED. It is a solid-state semiconductor device that converts electricity directly into light. The heart of the LED is a semiconductor wafer with one end attached to a holder, one end being the negative pole and the other end connected to the positive pole of the power supply, so that the entire wafer is encapsulated by epoxy.

As we all know, LED is a semiconductor product. If the voltage between two pins or more pins of the LED exceeds the breakdown strength of the component medium, it will cause damage to the component. When semiconductor devices are placed alone or loaded into a circuit, permanent damage to these devices may occur due to static electricity even if power is not applied. The pulse energy of static electricity can generate localized heat, so there is a direct breakdown of the lamp and the IC. This failure occurs even if the voltage is lower than the breakdown voltage of the medium. If you ignore anti-static at any point in production, it will cause the electronic device to malfunction or even damage it.

Therefore, we must do a good job of static protection and elimination measures to avoid unnecessary losses.


Static elimination and protective measures:


For the entire process (production, testing, packaging, etc.) all employees who are in direct contact with the LED must take measures to prevent and eliminate static electricity, mainly

1. Install an ion curtain machine at the door of the workshop.


2. Apply static eliminator, such as: ion fan.


3. The operator wears an antistatic suit with an antistatic wrist strap, gloves or an ankle ring.

4. Lay the anti-static floor and ground the workshop.


5. Soldering the soldering iron to make grounding measures.


6, the packaging uses anti-static materials.


7. The workbench is an anti-static workbench, and the production machine is well grounded.