Talk about the anti-static plastic film always need to pay attention to matters
Anti-static plastic film is suitable for the protection and preservation of graphic documents such as certificates, photos, newspaper clippings, specimen books, catalogs, restaurant menu work documents, etc. Generally, the thicker the plastic film, the higher the heating temperature of the plastic packaging machine. Generally, 80mic ~ 125mic requires a temperature of 90 ~ 100 ℃; 125mic ~ 150mic requires a temperature of 110 ~ 130 ℃; 175mic ~ 200mic requires 130 ~ 150 ℃ temperature. Such a plastic sealing effect will have a high degree of adhesion, good flatness, and a small edge gap.
Anti-static plastic film is a material used for plastic packaging of paper, generally containing plastic ingredients (PET + EVA), and is widely used for plastic sealing of identity, work, driving license, student card, representative certificate, marriage certificate, etc. It has waterproof, Dust-proof, moisture-proof, anti-static, anti-fading, anti-alteration, anti-breakage, anti-counterfeiting, anti-corrosion, high temperature and low temperature resistance, increased clarity and three-dimensional sense, etc., which is convenient for long-term storage. It is your life and work helper.
When the anti-static plastic film is molded, the set temperature is too low, the photo will be blurred and will cause incomplete sealing; it is sufficient to re-set the temperature again in the plastic package, if the temperature is too high, the film will be wrinkled due to overheating Fold, even roll the film into the machine. At this time, use the "temperature adjustment" knob to reset the temperature. Note on shutdown: In order to prolong the service life of the laminating machine, the heating power must be turned off first, and the power switch should be turned off after the machine is lowered to below 80 ℃ (about 5 minutes).
After molding, the plastic film may be very hot and very soft. Please handle it carefully. You can use books or other flat heavy objects to press the plastic seal to help keep the surface flat.