What are the characteristics of the sticky mat and how to use it
The sticky mat is mainly suitable for sticking to the entrance of the clean space and between the buffer zone. It can effectively stick the dust on the sole and wheel, and minimize the impact of dust on the quality of the clean environment, so as to achieve the effect of simple dust removal. It solves the problem that incomplete dust removal of other floor mats cannot ensure that the dust does not spread.
Each layer of the sticky mat is coated with a unique high-viscosity or low-viscosity adhesive size suitable for different places. The digital label facilitates the separation between the sheets. The multi-layer, straight-edged dust-tack floor mat can quickly and effectively remove the dust carried by the wheels and soles of transportation vehicles, keep the environment clean, easy to use, and the surface is contaminated. Remove the layer. Lightweight, easy to carry, quickly and effectively eliminate static electricity in the general range. At the same time, the more important point is that the sticky mat is mainly suitable for sticking to the entrance or buffer zone of the space that needs dust-proof purification. It can effectively stick the dust on the soles and wheels, and minimize the impact of dust on the quality of the environment. Therefore, the effect of simple dust removal is achieved, and the problem of incomplete dust removal on other floor mats cannot be guaranteed. Crack extension coefficient; bottom layer adhesive strength; tension; adhesive strength; medium, high, low, etc. The above is a simple process of understanding some special aspects of the sticky mat from a single aspect
So what is the use of sticky mat? First tear off the protective layer of the rubber surface from the opening on the back, and then place it on a clean and water-free access floor. Use the sole to flatten the sticky mat on the ground, and then tear it from the opening on the front. The lower protective layer, so that it can be used (if the surface of the film is covered with dust during use, tear off this layer from the opening, so that the next clean film can be used) You can see, the first step And the third step torn off is transparent, this is what we call the protective layer. The protective layer is used to protect the cleanliness of the sticky mat before it is used. In addition to the protective layer, each layer will be marked with 1, 2, 3, 4....30 in the corners in order to facilitate customers to change to a new layer after this layer is full of dust.