What are the requirements for the maintenance and use of anti-static table mats

Feb 28, 2025 Leave a message

What are the requirements for the maintenance and use of anti-static table mats?

Antistatic ESD mat roll

anti-static table mats

anti-static-mat

Specifications of insulating rubber table mats:
According to the voltage level, they can be divided into 5kv, 10kv, 20kv, 25kv, 35kv
According to the thickness, they can be divided into: 2mm, 3mm, 4mm, 5mm, 6mm, 8mm, 10mm, 12mm.

Technical parameters of anti-static table mat materials

Technical parameters of anti-static table mat materials Water absorption ≤1.5%

Tear elongation ≥250%, no deformation

Hot air aging at 70℃ for 72 hours

Smooth appearance, no bumps, good elasticity

The effective value of power frequency withstand voltage>15KV, maintain 3 seconds without breakdown

No more than 5 bubbles per square meter of 1cm2, the distance between any bubbles>=40mm, no cracks

What are the requirements for the maintenance and use of anti-static rubber mats?

(1) Test before use. Before each use, the upper and lower surfaces of the anti-static table mat should be inspected for appearance. If the anti-static mat is found to have defects that may affect its performance, such as cracks, damage, thinning, etc., which are insufficient to ensure insulation performance, it should be prohibited from use and replaced in time.

(2) Temperature. Anti-static rubber mats should be used in areas with an ambient temperature between -25 and +70℃.

(3) Protection during use. Anti-static rubber mats should be avoided from exposure to high temperatures and sunlight. They should also be avoided from contact with engine oil, grease, transformer oil, strong acids, and strong alkalis. They should be avoided from being pierced or scratched by sharp objects.

(4) When the anti-static work mat is dirty, it can be washed with soap at a water temperature not exceeding 65℃, and then dried with talcum powder. If the anti-static mat is stained with tar and paint, the contaminated area should be wiped immediately with an appropriate solvent to avoid excessive use of solvent. Gasoline, paraffin and pure alcohol can be used to clean tar and paint.

(5) Wet anti-static mats should be dried, but the drying temperature should not exceed 65℃.