What is the function of the anti-static wrist strap
The anti-static wrist strap introduces static electricity into the earth through the anti-static grounding wire through a 1 megohm resistor and wire in the plastic box on the wrist strap. The series connection of this resistor is mainly for personal safety.
Generally, there are three ways to deal with static electricity:
1) Direct discharge is to discharge static electricity to the ground through the electrostatic wristband;
2) Neutralize by the positive and negative ions in the air and the static electricity generated by itself;
3) Dissipate static electricity through power-consuming materials;


The wired anti-static wrist strap is discharged through a 1M ohm resistor. The purpose is to avoid the impact of instantaneous high current on the components and avoid device damage! During the inspection of the factory's electrostatic protection system, it was found that some measures did not play an anti-static effect. Effect.
Such as anti-static chairs, anti-static logistics vehicles, etc. If it works, you can test it. Triboelectric test can be done to detect, good things will not generate voltage higher than 10V.
The function of the 1M ohm resistor is to keep the impedance from the electrostatic source to the ground at a suitable resistance value, so that the static electricity can be quickly discharged to the ground without generating excessive current, damaging the equipment, and people will not feel pain. sense. Others such as the ground, desktop, logistics vehicles, workstation equipment, clothes, shoes, hats, gloves, etc. are the same.
2. The theory of cordless anti-static wrist strap is to use the principle of corona discharge to dissipate a part of static electricity. Corona discharge is also called front row discharge. After the conductor itself is charged, it usually requires a voltage of more than 1500V, and its front row will discharge to the air. , to dissipate static electricity, but the electrostatic voltage required for the wireless wristband to dissipate static electricity is too high, which is not suitable for the electronics industry, because how many electronic components can withstand high voltages above 1500V.

