Anti-static Mats Are Not Permanently Anti-static, Please Notice

Dec 07, 2018 Leave a message

Anti-static mats are not permanently anti-static, please notice!


Anti-static mats are mainly made of a variety of processes using conductive materials, static dissipative materials and synthetic rubber. The top layer is a static dissipative layer of about 0.3-0.5 mm thick, and the bottom layer is a conductive layer of about 1.5-1.7 mm thick. The mat has a long-lasting use, has good acid, alkali and chemical resistance, and is wear-resistant and easy to clean.


Recently, FA Technology contacted me via WeChat and wanted to buy a blue anti-static mat. Among them, the customer raised a question: Can this anti-static mat be permanently anti-static?


This answer is definitely not acceptable. The material of the anti-static mat has been explained above. Nowadays, many anti-static mats on the market are permanently anti-static. The anti-static mats sold by our company can guarantee the shelf life is 2 years. In 2 years, the antistatic coefficient will not exceed 10 ohms of 9th power, otherwise it will be replaced, and the product problems caused by improper use of human beings, such as color change, fading, scratching, abrasion, shrinkage, and resistance of the outer surface of the product, resistance value Wait until the requirements are not within the warranty. Avoid surface cleaning with volatile liquids such as alcohol, acetone, toluene, banana water, etc.

blue and green esd rubber mat.jpg

ESD curtain film testing picture.jpg

The anti-static mat has three precautions to ease his life:

1. The surface of the product is strictly prohibited from contact with acid-alkaline solvents (such as benzene, alcohol, etc.), which may cause discoloration, fading and resistance loss on the surface of the product. If cleaning is required, the cloth may be wiped with a neutral solution (such as water).

2. The glue used should be compatible with the bottom of the table mat product and the workbench material. It is not only firmly bonded, but also does not shrink after the product sticks. It is recommended that the test be pasted before mass production.

3. Product shrinkage: The rubber content of this product is higher than that of the general table mat on the market, the durability is increased, and the tensile strength is increased. It is recommended that the product specifications be extended and relaxed during the cutting, and stored for 24 hours, so that the product has a fatigue recovery. The process is followed by glue bonding production.