Anti-static wrist strap alarm
The function of the anti-static wrist strap alarm is to constantly check whether the anti-static wrist strap is effective and whether it meets the standard when worn. However, some alarms always only light up red or green when the power is turned on, regardless of whether the wrist strap is effective or not. If it is correct, it will not change.
At this time, there will inevitably be questions about whether the fault has occurred. This may not be the case. The method of inspection or adjustment is actually very simple. You only need a flat-blade screwdriver. Of course, the premise is that the anti-static wrist strap alarm is installed correctly and the grounding wire Effective grounding.
If the anti-static wrist strap alarm is always on in green, then without inserting the wrist strap, use a flat-blade screwdriver to insert the corresponding fine-tuning hole on the front (the side with the anti-static logo), and rotate it slightly to make it change. Just turn on the red light. If the anti-static wrist strap alarm always lights up in red, insert the wrist strap (make sure it is effective) and wear it correctly, insert a flat-blade screwdriver into the corresponding fine adjustment hole on the front, and rotate it slightly to make it bright Green light is enough. Of course, it is still necessary to check whether it is effective after adjustment. If there is still a problem, then it is recommended to replace a new anti-static wrist strap alarm.