Antistatic Floor Special Conductive Copper Foil

Nov 10, 2018 Leave a message

Antistatic floor special conductive copper foil

HAKKO 498 TESTER.jpg

First of all, you need to figure out a few problems. The copper foil is not the wire buried under the self-leveling floor. The wire is used for indoor wiring. The connection between the copper foil and the grounding wire is mostly through the terminal block (usually 6 terminals) Completed.

Can refer to the grounding method of the static eliminator, so it should be more clear


Anti-static ground construction and acceptance specifications, standards have certain requirements for all types of flooring, at least to meet the standard requirements to ensure quality and effect, as for the width of the copper foil, the spacing of the grid, the application of glue, set the grounding point Quantity, grounding system connection, etc. can be increased according to your requirements. In general, the laying method is to clean and level, then the grid is tiled in an orderly manner, the copper foil intersection should be at the center of the floor, copper foil connection Ground terminal, brush the glue, and then wait for the floor.

anti static mat application