How to fix the anti-static table mat rubber with the worktable panel
Laying anti-static table mat rubber on the workbench of the electronic workshop can effectively control static electricity and prevent the harm of static electricity to electronic products. What should I pay attention to when laying an anti-static table mat, and how to attach and fix the anti-static rubber?
Before laying the anti-static table mat on the workbench, first clean the work surface to avoid oil and dust as much as possible, and then determine the grounding method of the anti-static table mat, and then fix the rubber. For fixing, you can choose conductive glue or cloth-based strong double-sided tape. After the conductive glue is applied, you need to wait about 10-30 minutes until the conductive glue is not sticky. Use a roller to roll or beat the two surfaces to make the two surfaces completely fit, and put them into use 24 hours after the installation is completed. If you use cloth double-sided tape, it can be directly bonded. The correct and standardized laying method will not affect the use effect of the subsequent anti-static workbench.