How to use washable sticky roller
1. Correct use method: When using silicone wheels, please use the backward rolling method. (Especially cleaning uneven products, such as PCB boards)
2. Cleaning Silicone: Please wipe with dry alcohol, or dry with air gun.
3. Do not touch benzene and ester solvents (such as Tianna water, net washing water, film water, ethyl acetate, etc.) during use. Once contacted, immediately wipe with dry alcohol and blow dry with air gun.
4. For every 5,000 times of use, if the viscosity drops significantly, please note that this phenomenon is caused by the rubber wheel being contaminated. Take the following treatment, clean it with anhydrous alcohol in time, put it in an oven, and dry it at 50 ° C. Bake for 30 minutes and the viscosity rises. Use this method. The service life of our silicone wheels is more than 60,000 times. If the conditions are not available, clean them with alcohol, wrap them in a clean packaging film, and leave them for 48 hours. There has also been an increase in viscosity.
Matters needing attention:
1. It is strictly forbidden to use benzene and ester solvents (such as Tianna water, net washing water, film water, ethyl acetate, etc.) to clean the silicone. Such solvents will cause the silicone to swell, age, deform, and decrease viscosity rapidly. phenomenon.
2. Please do not use silicone wheels to clean the floor, wall, and rough boards: it is easy to scratch the silicone.
3. Please do not scratch the silicone with a sharp blade.
3. Maintenance and storage:
After use: Please use the silicone wheel to roll back and forth on the sticky paper several times to keep the silicone wheel clean.
Storage: Please keep away from benzene solvents, inks and curing agents, and put them in clean packaging.
When not in use: Avoid high temperature environments and direct sunlight.