Instructions for Using Sticky Mats
Sticky mats are primarily used at the entrances of cleanrooms, laboratories, or home entryways to effectively capture dust from shoe soles and wheels. To achieve optimal dust removal, please follow these instructions:
I. Installation and Securing: Clean the floor-ensure the surface is dry, free of water stains, and reasonably level. Remove the bottom film-locate the protective film on the underside of the mat, peel it off, and lay the adhesive side flat against the floor. Press down and expel air-step evenly across the mat to flatten it completely, ensuring there are no air bubbles trapped between the mat and the floor. Remove the top film-once secured, locate the top protective film (usually marked with a numbered tab), peel it off, and the mat is ready for use. II. Daily Use and Cleaning: Walking across-walk normally over the mat; dust and hair from your shoe soles will automatically detach and adhere to the sticky surface. Prolonged contact-pausing or stepping on the mat for a few seconds enhances the dust-trapping effect. III. Replacement and Maintenance: Peel off the used layer-when the mat's surface becomes saturated with dust and its adhesiveness diminishes, grasp the colored tab (marked with a number like "1," "2," etc.) and peel off the soiled layer to discard it. Reveal a new layer-removing the dirty layer automatically exposes a clean, fresh sticky surface underneath. Disposal-once all layers are exhausted (typically 30 layers), peel off and discard the backing sheet, then install a new mat unit.