Precautions for washing anti-static work clothes




When washing, the water temperature should be below 30C, add 1 gram of neutral soap or enzyme-free detergent per kilogram, and the bath ratio should not be greater than 1:40. Use a light washing method to avoid excessive friction and reduce the anti-static performance.
(2) Store in a dry and ventilated manner to avoid mechanical or chemical damage.
(3) Metal accessories must not be used when making work clothes. When it is necessary to use (buttons, zippers), it should be ensured that the metal accessories are not exposed directly when wearing them.
(4) When wearing anti-static jacket work clothes, it is forbidden to wear any metal objects with accessories on the clothing, and it is forbidden to put on and take off in flammable and explosive places.
(5) The newly sewn clean work clothes can be washed directly, and the recycled clean work clothes find oil stains, and the oil stains should be carefully removed before the washing procedure.
(6) Before washing the anti-static clothing, check the accessories such as scratches, damages and buckles, and repair, replace or scrap any defective ones.
(7) Cleaning, drying, and packing must be carried out in a clean room with a higher cleanliness than the clean room where the work clothes are used.
(8) The water used for wet and dry cleaning should be filtered, and the solvent should also be distilled. Use a filter membrane with a pore size of less than 0.2μm at the point of use, and filter more than once as needed.
(9) In order to remove water-soluble pollutants, anti-static take clean water to wash, and then use a solvent for the final washing to remove oily pollutants.
(10) Work clothes with buckles and anti-static clothes should be washed in the buckled state.
(11) Drying in a clean air circulation system dedicated to washing
(12) After drying, fold it in a clean room dedicated to washing, and put it in a clean polyester bag or bone bag. It can be double-packed or vacuum-plasticized according to requirements. The packaging material is preferably antistatic. material. Since the folding process is most prone to dust, the folding process must be carried out in a high-level clean space.

