Static dissipation of 6-9 ohm.
With the increasing demand for static electricity in the electronics industry, the resistance requirements of anti-static consumables have also increased. In the past, almost all injection molding products in the industry were made into 3-6 conductive types. Later, the electronics industry required them. The static dissipative type of 6-9 power is intended to make electronic components more secure, and the CDM effect occurs when electronic components come into contact with the storage container.
What is a static-conducting type: usually a product that has a sufficiently low resistance value to quickly bleed charge when the product is grounded or connected to any lower potential point. In general, the resistance of this product is below the 6th power ohm of 10.
Static Dissipative Type: This product slowly discharges charge when it is grounded or connected to any lower potential point. The resistance of this product is usually between 10 and 10 to 10 ohms. The same amount of charge has a short discharge time and a large discharge current on the conductive type product; the discharge time is long on the dissipative type product, and the discharge current is small. The HPL surface anti-static raised floor produced by our factory belongs to static dissipative type products.
Anti-static strip-shaped turnover frame specifications: 480*140*35MM can store 25 pieces of anti-static turnover frame made of anti-static plastic to eliminate static electricity. It has many advantages such as toughness, wear resistance, moisture proof, anti-corrosion, shockproof and heat insulation. The anti-static strip-shaped turnover frame is used for the turnover loading and storage of the PCB board in the production process.
Anti-static strip-shaped turnover frame; specifications: 480*140*35MM can store 25 pieces