The characteristics of the sticky roller and the cause of the malfunction
1. What are the important characteristics of the sticky roller?
Firstly, the base of the dust roller is made of polyethylene film. The dust film is provided with pre-cut lines. The edge of the roller is peeled off for easy stripping. The dust roller is not only advanced and reasonable in design, but also can remove dust well and avoid the tradition. The pollution caused by the appliance. More importantly, it is easy to use and can quickly and effectively remove the dirt on the floor, roof, walls, table top and other surfaces of the clean room. It is similar to the roller that paints the wall and consists of the handle of the roller. When the sticky roller is used, it only needs to roll on the surface to be cleaned like a painted wall. If the drum becomes dirty, the soiled layer cannot be torn off along the crease when the dirt is adsorbed.
2. The sticky roller drives the conveyor belt or a cylindrical assembly that changes its direction of travel. What is the main reason for such a material to fail when it is running?
Whether the air pressure of the sticky roller is abnormal, such as whether the air pump is abnormal, whether the air pipe is leaking or blocked; whether the brake disk on both sides of the sticky roller is defective; whether the brake system is faulty or not, and the brake command is not smooth; Whether the brake block is damaged; whether the power transmission system cuts off the power in time; for the belt type friction brake, check whether the friction belt is loose or the friction factor is reduced, and should be adjusted or replaced. Mainly from the above five aspects to understand the reasons for the failure of the sticky roller.