How to do anti-static at gas station

May 24, 2019 Leave a message

                                                          How to do anti-static at gas station


The main factors that generate static electricity at gas stations are: the static electricity generated by the automobile tanker during the oil transportation process; the storage tank generates static electricity during the loading and unloading process; the oil flows in the oil pipeline to generate static electricity; the oil flows through the filter, pump and metering Static electricity is generated when the device is used; the operator generates static electricity from the human body. Gas stations should pay attention to the following points in their daily work:



1. Connect the electrostatic ground wire before unloading the oil.

The oil pipeline and the oil storage tank are equipped with an electrostatic grounding device. Before the oil is unloaded, the electrostatic grounding wire must be connected. Normally, it should be stuck in the bare metal part connected to the oil tank and the oil tank. operation.


2, detecting the grounding resistance value

The lightning protection and anti-static grounding device of the gas station detects its effectiveness at least every year before the thunderstorm season. The grounding resistance of oil tanks, station houses and sheds shall not exceed 10 ohms; all tankers and oil guns must ensure good equipotential bonding, grounding resistance is not more than 4 ohms; distribution boxes must have good lightning protection grounding wires, metal shielding The two ends should be well grounded, the grounding resistance should be no more than 4 ohms; the resistance of the oil pipeline should not exceed 30 ohms, and the electrostatic grounding resistance should not exceed 4 ohms when unloading.

3. Always check the electrostatic connection between the metal shield wire on the rubber hose and the body.

The electrostatic connection between the shield wire on the tank of the dispenser and the body is often broken, which may cause breakage, resulting in an electrostatic accident. A gas station has experienced a deflagration accident in the fuel tank of the fuel tank during the refueling process. The inspection is caused by the breakage of the electrostatic grounding conductor on the fueling gun. Therefore, the operator should always check the integrity of the electrostatic grounding wire on the grease gun hose.


4. It is strictly forbidden to directly add gasoline to the plastic barrel.

When directly injecting gasoline into an insulated plastic drum, the static electricity of the oil in the barrel is accumulated due to the insulation of the plastic, and the electrostatic voltage rises rapidly. When the electrostatic voltage rises to the electrostatic discharge voltage, the electrostatic discharge fuel is generated. Steam, a fire accident. The correct operation is to add the oil to the iron drum, then put the iron bucket into the safe area, and inject the oil into the plastic bucket through the funnel. When filling the iron drum with oil, it is necessary to ensure that the muzzle touches the bottom of the bucket, cannot be sprayed, and the flow rate should be controlled to be no more than 1 m/s.

5. It is strictly forbidden to directly add gasoline to the motorcycle fuel tank or automobile vaporizer.

Can not directly add fuel to the motorcycle fuel tank because: most motorcycle fuel tanks are made of plastic, which is equivalent to filling the plastic drums; and the motorcycle engine is under the fuel tank, the temperature is high after the flame has been extinguished, in case the oil drops There is a danger of burning fire.

Adding gasoline directly to the car carburetor is prone to tempering and igniting the oil outside the engine.


6, the operator should wear anti-static overalls to eliminate static electricity