How to remove the plastic film layer to be removed from the sticky pad
After the sticky pad has been used for a period of time, the surface film will be contaminated, and the surface film needs to be removed. Many people start with the corner containing the logo and peel it off in a straight line. Doing this will easily cause the pollutants adhered to the sticky pad to fly up and enter the clean room through air flow. It is strongly recommended that you use the following process to remove the plastic film layer to be replaced:
1. Search for the color code on the edge of the cushion;
2. Take out the logo and gradually separate the plastic film layer from the edge of the cushion;
3. Pull the plastic film upward again to separate it from the cushion until all four corners are separated from the cushion;
4. Pull the four separated corners to the center of the cushion to create an outdoor tent shape.
5. Slowly separate the plastic film in the middle of the cushion;
6. Unfold the plastic film inward until it is small enough to be discarded.
7. Polluted plastic films should be thrown outside the dressing room. Workers should not pull the logo or pull the plastic film off the cushion at will, but should follow the above process to slowly peel off the plastic film. When the surface of the plastic film is covered with dust during use, the viscosity of the dust-stick mat will decrease. At this time, this layer of dusty floor mat must be removed. It is also important to remove dusty floor mats. First, slowly separate the four corners of the anti-fouling pad from the pad, then approach the center, wrap the dust inside, and stretch the plastic film inward until it is small enough to be thrown away. In this way, the pollutants adhered to the dust removal pad will not fly around to ensure the dust removal effect. The sticky dust pad has strong adhesion, does not peel off, can be used more than 100 times, is easy to replace, does not require mopping or water cleaning, and has a storage period of 1-3 years.