Advantages and usage of hospital sticky pads
Hospital sticky mats are used at the entrance and buffer area of the operating room.
1. How to use: 1. When using the sticky mat, first tear off the protective layer of the adhesive surface from the opening on the back, then place it flatly on a clean and water-free floor, and press the sticky mat with the soles of your shoes. Level with the ground, and then tear off the protective layer from the opening on the front; 2. When the sticky film of the sticky pad is full of dirt, peel it off and use a new layer of sticky film underneath, so there is no need to clean and wash; 3. , non-slip and non-staining, won't be damaged by shoes or wheels, easy to remove and leaves no trace.
2. Advantages: 1. It can effectively remove dust from soles and wheels, minimize the impact of dust on the quality of the purified environment, and solve the problem of incomplete dust removal on ordinary floor mats and the inability to ensure that dust does not spread;
2. The sticky pad can not only remove dust alone, but also remove dust from the manual silicone rubber wheel to ensure the recycling of the silicone rubber wheel. The glue polymer molecules on the surface of the paper are high-density and can absorb fine particles;
3. The surface of the sticky pad will not deglue under strong friction, the glue density is evenly distributed, and the glue is environmentally friendly and has no odor;
4. To make it easier to remove during use, there is a page number label on the corner of the sticky pad. is a reusable dust removal mat, it can remove dirt from tires with just the weight of vehicles passing by, the dirt from the mat can be removed simply by wiping it, it does not create any extra garbage because you can use it again and again.
After the hospital sticky pad has been used for a period of time, the surface film layer will be contaminated. At this time, the surface film layer needs to be removed. Many people start with the corner with the label and remove it diagonally. Doing so can easily cause contaminants attached to the sticky pad to fly up and enter the clean room through air flow. It is recommended that you use the following steps to remove the film layer to be replaced:
1. Look for the color label on the edge of the mat;
2. Pick up the label and slowly peel off the film layer from the edge of the mat; 3. Continue peeling the film upward to separate it from the mat until all four corners are separated from the mat;
4. Pull the four separated corners to the middle of the mat to form a tent shape. 5. Slowly separate the film in the middle of the mat;
6. Fold the film inward until it is small enough to discard.
7. Contaminated film should be thrown outside the locker room. Staff should not tear off labels or tear off the film from the mat at will, but should follow the above steps to slowly remove the film. When the film surface is covered with dust during use, the viscosity of the dust-stick mat will decrease. At this time, it is necessary to tear off this layer of dusty floor mat. It is also important to remove dusty floor mats. First, slowly separate the four corners of the dustproof pad from the pad, then move closer to the middle, wrap the dust inside, and fold the film inward until it is small enough to be discarded. In this way, the contaminants attached to the dust removal pad will not fly around to ensure the dust removal effect. The sticky dust pad has strong adhesion, does not peel off, can be used more than 100 times, is easy to replace, does not require mopping or water cleaning, and has a storage period of 1-3 years.