Why anti-static workbench is anti-static
First of all, the anti-static workbench is guaranteed to have anti-static energy. Generally, the supplier will customize the anti-static workbench according to the size of the rejection. This is not a concern. Secondly, there must be an anti-static table mat and an anti-static ground wire on the desktop. The anti-static material is used for the bracket, and the conductivity is 106Ω, so that the overall effect of anti-static is exceeded. Finally, when testing, don't just test the antistatic index of the table, you should check the antistatic performance and the resistance to ground as a whole, because the overall antistatic function refers to preventing the occurrence of static electricity at the source again. Also pay attention when ordering. Some factories use it for ordinary workbenches, but just put an antistatic pad on the worktop. In fact, it is right or wrong to do so. However, static electricity cannot be discharged in a timely manner. In addition, static electricity may be generated in other parts of the ordinary workbench. Therefore, the entire desk must be antistatic sprayed as a whole. A qualified anti-static workbench should meet the following three points: 1. The overall surface resistance of the anti-static workbench sprayed surface must meet the anti-static rejection. 2. The overall short-circuit resistance of the anti-static workbench should conform to the anti-static rejection. (Volume resistance from desktop to table legs). 3, the surface resistance of the anti-static work surface should meet the anti-static rejection.