1. Environmental requirements
Humidity: 40%-60%
Temperature: 10 ° C -25 ° C
2. Preparation - cleaning
The work surface must be cleaned before starting to lay the mat. In the case of detergents, domestic cleaners can be selected. If there is oil, special detergents for oil removal can be selected. It should be noted here that it is not recommended to use detergents such as xylene, which may cause harm to the body when inhaled by employees.
3. Installation steps
(1) Determine the grounding method
There are two ways to ground: use an anti-static grounding wire buckle, or place copper foil on the table top.
If the grounding method is an anti-static grounding wire buckle, first insert the star claw buckle into the cut anti-static table mat.
If the grounding method is copper foil, the copper strip or aluminum strip with a certain quantity and length shall be laid on the countertop according to the requirements of the mesa laying. The copper foil or aluminum foil must be reserved for connecting the grounding wire. In this process, in order to allow static electricity Release to the ground through the ground wire.
(2) Fixation of the table mat
After determining the grounding method, the relevant operation can be completed and the laying of the table mat can be started.
Apply a conductive adhesive to a clean and dry countertop. It can also be fixed with a strong double-sided tape or a universal adhesive. After applying the super glue, wait for about 10-30 minutes, wait until the conductive super glue or the universal glue is not sticky (the double-sided tape can be directly bonded), and bond the anti-static table mat to the table top with a roller or a small hammer. Rolling or beating makes the surfaces of both sides straight, and can be used after 24 hours of installation.
Special attention: be sure to choose high-quality glue, inferior glue will cause foaming and bulging between the table mat and the table!
Floor mat laying method
1. Basic ground requirements
(1) The foundation floor may be a cement floor with a smooth surface, a terrazzo floor, a tile floor, or a wooden floor.
(2) The ground must be flat, without obvious unevenness, and the unevenness should be less than two thousandths.
(3) The ground has sufficient strength and no sanding or shelling.
(4) The ground must be dry.
2. Construction procedures and specific methods
(1) Wash the waste on the ground with a cleaning solution or xylene (with a washing machine)
(2) The thickness of the copper strip for grounding conductive grid laying is 0.02mm and the width is 20mm. The number of strips is determined according to the actual width requirement of the ground. The direction of the copper strip is perpendicular to the direction of the anti-static mat, and the strip spacing is 2-3m. One), at the same time, lead one end of the laying copper strip to the outdoor grounding pole of the earth.
(3) After the grounding conductive mesh is laid, the anti-static mats are placed on the ground in turn. If the gap between the mats is too large, the knife can be straightened to make the gap smaller. Turn the edge of the laid anti-static mat on the floor mat (about 500px), apply glue (universal glue or double-sided tape) in the middle of the gap, and dry for 20-30 minutes, so that the hands are not sticky (double-sided tape immediately It can be glued), then the anti-static mat is bonded to the ground, and then rolled with a heavy roller several times to make the surface of the anti-static mat neat and straight (if there is heavy roller rolling by hand or Use your foot) and use it after 48 hours at room temperature.