Anti-static mat performance and use
The anti-static mat has a good anti-static and conductive effect by using a production process of the bottom layer as a conductive layer.
Comply with American MIL-STD-1686C, MIL-HDBK-263B and GJB1649-93, GJB3007-97 standards.
Product specifications 2.0mm*600mm*10m; 2.0mm*1000mm*10m; 2.0mm*1200mm*10m
Performance parameters Surface layer (static dissipative layer) resistance 107 Ω- 109 Ω Friction static voltage <100V
Ground layer (conductive layer) resistance 103 Ω- 105 Ω friction electrostatic position < 50V
Abrasion rate: <0.02g/cm2 Electrostatic voltage decay period: 5000-500V < 1.9S
Volume resistance : 107-1010 Ω CM Static dissipation time: <0.5s
Anti-static mat (floor mat) physical performance indicators
1. Tensile strength: 3.6Mpa
2. Elongation at break : 188%
3. Tear strength (right angle): 20.6KN/m
4. Resilience (sample consists of 6 layers of sheets): 14%
5. Impact embrittlement temperature (no cut) -250c : no damage
6. Compression permanent rate of change 700Cx22h. Compression 25%: 17.9
Color Available in green, gray, blue, black, etc.
Features: Anti-static mats are mainly made of anti-static materials and synthetic rubber materials. The surface layer was a dissipative electrostatic layer of about 0.5 mm thick and the bottom layer was a conductive layer of about 1.5 mm thick. It is commonly used as a 2mm double layer composite structure. The mat has a long-lasting use, has good acid, alkali and chemical resistance, and is wear-resistant and easy to clean. The conductive mat is made of high-quality conductive material synthetic rubber.
Scope of application: Production workshops and advanced laboratories in the microelectronics industry such as electronic semiconductor devices, electronic computers, electronic communication equipment and integrated circuits
It is mainly used for laying table tops, assembly line countertops, shelves and making floor mats, and is suitable for different conditions and different environments.
Characteristics:
The static electricity of the human body is released, so that the ESD scorpion, tools, instruments, instruments, etc. on the table surface reach a uniform potential, so that the electrostatic sensitive device (SSD) is not interfered by the electrostatic discharge phenomenon, thereby effectively buffering the electrostatic protection effect and avoiding the device. Damaged.