Instructions for use of blue sticky mat:
First, tear off the protective layer of the adhesive surface from the interface on the back, then flatten the glass sticker and place it on a clean and water-free floor, use the sole of the shoe to flatten the blue sticky mat on the ground, and then tear off the protective layer from the interface on the front, and then you can use it (if the surface of the film is covered with dust during use, tear off this layer from the interface, so that the next layer of clean film can be used again) You can see that the first and third steps tear off the transparent layer, which is what we often call the protective layer. The protective layer is used to protect the cleanliness of the blue sticky mat before it is used. In addition to the protective layer, each layer will be marked with 1,2,3,4...30 in the corner in order, so that customers can replace it with a new layer after the layers are messy.
The adhesive of the blue sticky mat is produced by a new chemical method, energy-saving pressure-sensitive water-based adhesive, which can make the entire surface of each layer of the blue sticky mat have uniform adhesion. No glue falling off, colorless, odorless, and non-toxic.