As long as there is a way, ordinary chairs will become anti-static chairs.
Intense market competition, technological innovation, product upgrades, and more and more anti-static products used in modern electronic processing plants. However, the cost of updating all existing production equipment and work tools can not be underestimated. For example, many electronic factory production lines use ordinary work chairs, and it is more expensive to replace them with anti-static chairs. There are also many other equipment to be replaced, which is difficult to bear in many electronics factories.
So can you use the original non-anti-static things? There is no good way to achieve anti-static requirements without replacing the original work chair. The answer is yes.
The solution is to use an anti-static seat cover to solve such problems. Don't underestimate this anti-static seat cover, its production is also very knowledgeable. Firstly, the fabric should be made of mesh conductive silk fabric with good wear resistance and good electrostatic properties. Secondly, the seat cover of the seat back and the seat cushion should be connected by conductive tape (the connecting line must be made of conductive wire), and finally the seat cushion seat cover should also be used. Conductive tape connection (conductor must use conductive wire), but be sure to pay attention to the conductive tape of the seat cushion must be in contact with the anti-static floor, in order to ensure the discharge of static electricity.