Performance characteristics and use steps of sticky mat
Each layer of the sticky mat is coated with a unique high-viscosity or low-viscosity adhesive viscosity agent for different locations. The digital label facilitates the separation between the sheet and the sheet. The multi-layer, straight-side sticky floor mat can quickly and effectively remove the dust carried by the wheel and the sole of the vehicle, keep the environment clean, easy to use, the surface is contaminated, and the layer is torn off. Lightweight, easy to carry and quickly and effectively eliminate static electricity in the general range.
At the same time, the more important point is that the sticky mat is mainly suitable for sticking to the entrance or buffer zone where dustproof space is needed. It can effectively remove the dust on the sole and the wheel, and minimize the dust to the quality of the purifying ring. The effect is to achieve the effect of simple dust removal, and solve the problem that the dust removal of other floor mats is not completely impossible to ensure the dust does not expand.
Crack elongation coefficient; underlying bonding strength; tension; bonding strength; medium, high, low, etc. The above is a simple process to understand some special aspects of the sticky mat from a single aspect. It can also be understood from other different angles.
First, remove the protective layer of the rubber surface from the opening on the back, then place it flat on the clean and unwatered floor, and use the sole to flatten the sticky mat to the ground and then tear it from the opening at the front. The lower protective layer, so that it can be used (if the surface of the film is full of dust during use, the layer is torn off from the opening, so that the next layer of clean film can be used), the first step can be seen. And the third step is to peel off the transparency, which is what we call the protective layer. The protective layer is used to protect the sticky mat from being clean before it is used. In addition to the protective layer, each layer will be marked with 1, 2, 3, 4....30 in the corners in order, so that the customer can change to a new layer after the layer is dusty.