Structural characteristics of antistatic turnover car
Material: Stainless steel frame, conductive PPE injection slot plate (PPE is a high-performance thermoplastic engineering plastic, has excellent conductivity) conductive pulleys, etc.
Steps:
1, first, connect an outer frame with 4 support round rods and tighten with screws;
2, put the required PCB slot board on the round rod, pay attention to the single panel at the two ends, double panels can be placed in the middle;
3. Install another frame and tighten with screws;
4. Install anti-static casters, which can be clamped with strong pliers;
5. Adjust the distance according to the size of the PCB board.
The above is a brief introduction about anti-static turnover car. Now everyone should know the little knowledge about it!