Use and maintenance of anti-static floor
1. Anti-static ground (anti-static cast-in-place terrazzo ground, anti-static polyethylene ground, anti-static polyurethane self-leveling ground, anti-static raised floor ground) should always keep the surface clean during use. You can use a duster or a wet mop (not dripping) to clean the floor. If there is dirt, you can moisten the surface with a neutral ear cleaner, and then wipe it clean.
2. During use, it is strictly forbidden to roll or scratch the ground with hard tools; high-temperature objects (electric soldering iron, electric stove, etc.) and low-temperature objects (dry ice, liquid nitrogen, etc.) are strictly prohibited from directly contacting the ground; oil lamps and corrosive chemicals should be avoided. ground.
3. Instruments and equipment with edges and corners and a hard chassis shall not be dragged on the ground. Do not place objects on the ground that exceed the load-bearing capacity of the anti-static ground design.
4. Equipment with rubber pads and rubber wheels should not be placed directly on the anti-static polyethylene floor for a long time.
5. When disassembling the anti-static raised floor, you must use a suction board, and it is strictly forbidden to use sharp tools and other tools to lift, pull, beat, or smash. The support pad should be added when the area of the support point of the heavy object is small.
6. The method of coating anti-static floor wax should be adopted to maintain the ground, and it is strictly forbidden to use non-anti-static floor wax