Anti-static operation specification for workshop production site
1. The operation of all components must be carried out on an electrostatic safety workbench. All components that enter the anti-static work area must be treated in accordance with anti-static requirements.
2. SMD devices without anti-static packaging shall not enter the production site.
3. When taking out the parts from the static protection container, it should be carried out on the static safety workbench. As a worker, the following three points must be observed:
(1), must wear anti-static overalls.
(2) Wear an anti-static wrist strap, which has good contact with the skin and is reliably grounded.
(3) When touching precious SMD components, it is best to wear an anti-static ring or finger cot.
4. For components without anti-static packaging, they should be eliminated before entering the static work site.
5. A monitor should be equipped on important operating stations to detect whether the wristband is in a normal state at any time.
6. Ordinary clothing, drawings, documents, etc. shall not touch the components.
7. When holding sensitive devices, avoid touching their leads and lugs.
8. When some components need to be cleaned, plastic brushes cannot be used, and anti-static brushes must be used for cleaning.
9. All tools, fixtures, equipment and instruments without anti-static function that must be used at the operation site should be placed on the anti-static table (table) pad.
10. It is forbidden to reuse device packaging tubes to package components.
11. When welding by hand, use an anti-static low-voltage soldering iron.
12. A low-voltage DC electric screwdriver with a grounding wire should be used.
13. Outsiders who enter the site without anti-static measures are not allowed to touch the components.
14. Various equipment at the production site must take anti-static measures.