Air gun nozzle maintenance method
1, power supply, gas source requirements
1. The power supply must have a ground wire and be fully grounded. The transformer must be well grounded and the ground wire knob should be checked for tightness before each use.
2. The gas source used must be effectively filtered. Sometimes a secondary filtration unit is needed. The filter should be cleaned in time. Otherwise: water, oil and dust/dust particles enter the ion generation chamber and adhere to the inner wall of the plastic part. When accumulated to a certain extent, the ion needle will ignite it. As a result, the plastic parts gradually form a honeycomb focal length, and the amount of ion removal is gradually reduced; in particular, a safety hazard is generated.
3, to cooperate with the power supply produced by our company, do not buy fakes.
2, in addition to the electrostatic effect adjustment
1. In addition to the electrostatic effect, the static electricity time is inversely proportional to the air pressure. The air pressure should be 0.3Mpa-0.7Mpa.
2, the distance between the gun head, the wind mouth and the electrostatic field, the angle affects the effect of static electricity, should pay attention to debugging until satisfactory.
3, routine maintenance
1. The air gun/wind nozzle is easy to break. Pay attention to the anti-collision when using the air gun, and pay attention to the anti-fall after use. Even if the air nozzle is fixedly installed, take care to prevent object collision.
2. The air gun air pressure regulating valve is moderately and appropriately put into the universal anti-rust lubricating fluid.
3, when cleaning the air gun air nozzle ion needle and ion needle room should use anhydrous alcohol can not use the day to take water. When cleaning, first power off, then use the camera to unscrew the small plastic cover (also called air accelerator) in front of the wind gun head, use a cotton swab dipped in anhydrous alcohol to clean the ion needle and the ion needle chamber, inside the inside The stains and dirt are cleaned.
4, the air supply of the air gun is best to add a foot switch, or through the electromagnetic valve and mechanical action linkage control, not only can improve the use of the effect, but also extend the service life.
4, other see instructions
5, warning
1. Ion air gun and air nozzle are precision and sensitive static products. Must meet the conditions of use!
2, the use of ungrounded power supply, unclean air source conditions, and failure to use the failure, damage and other consequences are not covered by our warranty and responsibility.
Second, the wind guns that are returned for maintenance are mostly in 2005, because the high-voltage line is easy to be old under the action of high electric field for a long time.
It is time to change. Air Gun Our company has already launched the new SL-004D, which is durable and durable, safer and more reliable.
Third, high-voltage power supply testing, to use high-voltage electricity meter to detect. Simple detection can determine whether there is a high voltage output by arc resistance at the high voltage output. As for its performance, it is necessary to use high voltage voltage detection. At the same time, take a 500P.1000P.1500P capacitor and observe the change of its output voltage. The smaller the voltage change, the better.