Anti-static work clothes manufacturing process requirements
A good quality anti-static work clothes is not only the material performance itself, but also the quality of workmanship is very important. The relevant standards of anti-static work clothes mainly include the following three points:
1. Seams. The most suitable seam preparation depends on the required protective properties! Therefore, only after having a comprehensive understanding of the different characteristics of seams, tape-sealed needle seams, fusion seams and combined seams, can you make the right choice! Suture gauge: (12~14) Needles/3cm (mass per unit area ≥ 200g/㎡), (14~16) needles/3cm (mass per unit area<200g/㎡)
2. Size. The size of the anti-static clothing should be moderate, neither too large nor too small. General manufacturers are afraid of trouble, and generally choose one size fits all, so it is inevitable that the size will be too large or too small. Especially for some one-piece anti-static clothing, if the size is too large, the loose clothes will not only be uncomfortable to wear, but also cause inconvenience to the movement, and even affect work efficiency; Can hinder work activities and tear easily, seriously weakening the protective performance of work clothes.
3. The accessories of anti-static work clothes are generally not allowed to use metal accessories. If they must be used (such as buttons, hook loops, zippers), the surface should be covered, and the metal accessories should not be directly exposed.