It is safer to use the static dissipative type of 6-9 power
As the electronic industry has higher and higher requirements for static electricity, the resistance requirements of anti-static consumables have also been improved. In the past, injection molding products in the industry were almost made of 3-6 times conductive type. Later, the electronic industry required the use of The static dissipative type of the 6-9th power is designed to make the electronic components safer. The CDM effect occurs when the electronic components touch the storage container.
What is the conductive type: usually a product, it has a sufficiently low resistance value, when the product is grounded or connected to any lower potential point, it will quickly discharge the charge. Under normal circumstances, the resistance of this product is lower than 10 to the 6th ohm.
Static dissipative type: The product will slowly discharge charge when it is grounded or connected to any lower potential point. The resistance value of this product is usually between 10 6th power and 10 10th power ohms.
The discharge time of the same amount of charge on the static conductive product is short, and the discharge current is large; on the dissipative product, the discharge time is long, and the discharge current is small. The HPL surface anti-static raised floor produced by our factory is a static dissipative product.
Anti-static strip-shaped turnover rack specifications: 480*140*35MM can store 25 pieces of anti-static turnover racks are made of anti-static plastic, which can eliminate static electricity. It has many advantages such as toughness, wear resistance, moisture and corrosion resistance, shock resistance and heat insulation. The anti-static strip turnover rack is used for the turnover loading and storage of PCB boards in the production process.
Anti-static strip turnover rack; Specification: 480*140*35MM can store 25 pieces