Which method is the easiest to install an anti-static push cart
The anti-static push cart can be used for 2-3 years under reasonable use and maintenance. It can be washed directly without water and wiped with a dust-free cloth. Do not disassemble at will, and do not place heavy objects unrelated to the circuit board.
The easiest way to install an anti-static push cart:
1. First, connect an outer frame with 4 supporting round rods and tighten them with screws;
2. Put the required PCB slot plate on the round rod, pay attention to the single panel on the two ends, and the double panel on the middle;
3. Install another outer frame and tighten it with screws;
4. Install anti-static casters, which can be clamped with pliers;
5. Adjust the distance according to the size of the PCB board.
1. All staff entering the work site must wear anti-static clothing, anti-static shoes, anti-static caps, and anti-static wristbands.
2. When touching products and parts with hands, you must wear anti-static wristbands, anti-static gloves or anti-static finger cots.
3. All electronic parts and assemblies are considered electrostatic discharge sensitive parts. When handling and picking up all electronic assemblies, do not touch their circuits, except for the needs of the process
4. The transfer of anti-static sensitive parts must be in a suitable container. Any anti-static sensitive parts that are not properly packaged are not acceptable and only ESD-protected personnel in an electrostatic discharge protected area should unpack the anti-static sensitive parts.
5. Be sure to do a good job of electrostatic protection when taking out electrostatic discharge sensitive parts, and ensure that the surface of the workbench is covered with anti-static table mats. Make sure ESD protected area devices are properly connected and functioning properly.