Anti-static SMT loading and unloading rack installation steps and precautions
Precautions:
The anti-static SMT loading and unloading rack is currently mainly suitable for automatic loading and unloading machines, and can be resistant to acid and alkali, oil stains, high temperature, non-toxic and odorless, and can be used for
It holds PCB boards, and brings convenience to cleaning, so that the circuit boards in production are convenient to turn over, stacked neatly, and easy to manage. Its reasonable design, excellent quality,
It is suitable for the transportation, distribution, storage, circulation processing and other links in the factory.
The main steps of SMT loading and unloading rack installation:
1. First choose the accessories. The accessories include: the upper and lower material rack plastic, and two plastic side panels, two bottom panels (fixed board, movable board), aluminum alloy
There are four columns, a hexagonal socket screw and a washer, a metal stop rod, and a hexagonal wrench for tools. .
2. After selecting the accessories and tools, you can install it. First, fix the four aluminum alloy columns on a metal base plate with screws. (Each
There are washers under the screws) Tighten the screws to prevent shaking.
3. Fix a piece of fixed side plate on the metal fixing plate of the screwed column, tighten the screws as before, and then fix another piece of metal to fix it
board. When installing this fixed base plate, pay attention to slightly unscrewing the screws, but fix it so that it does not slip off the column.
4. The fourth step is the most critical. If this step is not well installed, the previous work will be done in vain. Is to install the movable side panel, just said solid
Do not tighten when ordering another bottom plate. This is how the movable side plate can be easily anti-static. First aim at one side (upper side or lower side)
Place the bottom end of the gear directly, and then slide the movable plate on the other side slowly along the gear to this side to see if the top and bottom are aligned, and whether the movable buckle below can fit into the bottom plate chute. If everything is fine, then See if the movable buckle above can also fit into the chute on the bottom plate, Ok,
There is no problem, then the next step is to tighten the screws of this base plate.
5. The fifth step has been done perfectly, this step is very good, that is, slide the movable side plate from the side just installed along the gear groove to the other side. It is also very important at this time. When moving, you should slightly lift the two plastic wrenches on the movable side plate, so that the movable side plate can easily slide back and forth along the sliding groove and gear.