Are there any requirements for the wiring of the anti-static workbench?
After choosing the anti-static workbench, you must learn how to wire it when you use it. If the operation is improper or the wiring is wrong, the workbench will not have the anti-static effect. So, what are the requirements for the wiring of the anti-static workbench?
1. Wiring specification requirements for anti-static workbench
1. Determine the size of the anti-static workbench. The measurement must be carried out in accordance with the correct standard. It cannot be too large or too small, otherwise it will affect normal operation.
2. In order to ensure the service life of the anti-static workbench, it is necessary to wipe the parts of the anti-static workbench with alcohol frequently and keep it clean at all times.
3. Lay the foil tape, but there are requirements, the aluminum foil is only allowed to overlap at the fold. You can press down the knob connector from the front of the anti-static table pad and replace it with other nuts, and then require it to pass through the anti-static table pad and foil tape, so as to ensure good contact.
4. It is necessary to lay the anti-static floor mat well, and the anti-static workbench must be completely placed on the anti-static floor mat, so as to ensure sufficient safety.
5. The ground wire of the anti-static workbench should be laid to prevent a lot of inconvenience caused by the modification. After the installation is completed, it must be checked before it can be put into operation.