Installation and maintenance of human electrostatic discharger
Use and installation method:
Installation method: The total height is 1 meter. With the base, firstly put the Φ10 screw on the grounding wire and screw it on the bottom nut of the stainless steel pipe. Connected to the ground wire, the installation is complete. The static electricity on the human body can be drained by touching the ball. The grounding wire is preferably connected to the lead of the grounding wire by a wire of not less than 0.3 squares, and the other parameters are the same as above.
There is a small hole in the ball seat. There is an electrostatic indicator light in the hole. If you have static electricity in your body, just touch the metal ball with your finger (one second) to eliminate the static electricity of the human body. (The indicator light is off and then extinguished. ). It is obvious at night and the day is not obvious. If the static electricity in your body is less than 100V or there is no static electricity, the static indicator will not light. .
maintenance:
When moving the white steel pipe before installation, it should be handled gently. This is because there is a circuit original in the steel pipe, and the steel pipe does not enter debris, especially metal objects, such as entering the metal circuit can not work normally. Because the sphere and the steel tube are insulated from each other, no other metal can be placed close to the sphere.