The main purpose of anti-static finger cots in the electronic processing industry
The anti-static finger cot is made of 100% concentrated natural latex and anti-static glue. It does not contain silicone oil or ammonia. It has been chlorinated to effectively prevent static electricity. It has very good protection for the fingers and can safely release the staff. Electrostatic charge of the human body. The main types are cut finger cots, orange non-slip finger cots, white dust-free and powder-free finger cots, clean dust-free finger cots, pink anti-static finger cots, transparent non-slip finger cots, transparent frosted finger cots, black anti-static finger cots, etc. .
Anti-static finger cots are mainly used in the electronic industry, optical industry, microelectronics, plastic parts, clocks and biopharmaceutical production process operators to wear a kind of protective equipment, finger cots ultra-thin fingertips are conducive to flexible finger operation and easy to wear, It is convenient for the staff to handle extremely small parts. The finger cots contain anti-static liquid ingredients, which not only prevent human sweat, fingerprints and static electricity from harming the product, but also effectively isolate the finger from contact with other corrosive liquids to avoid skin allergies and prevent nails from leaving on the product. Scratches.
Anti-static finger cots need to be tested for their anti-static value before use. The test is performed under the conditions of room temperature 26℃ and 45% relative humidity. We usually pay attention to the following points when wearing gloves:
1. When used for waterproof operation, check the air leakage first. You can blow into the finger cuff, and then pinch the mouth tightly to see if the finger cuff has become smaller. If it becomes smaller, it means that there is a leak and it cannot be used.
2. If you feel your fingers feel numb, swollen, or purple during wearing, you should remove them immediately and raise your fingers, and the symptoms will gradually disappear.
3. After use, it should be dried in the shade (not exposed to the sun). It can be used repeatedly. If it is difficult to wear after repeated use, put some prickly heat powder or talcum powder for lubrication.
4. Roll it up from top to bottom when it is used up and take it off, so that it is easy to take off and will not break and is convenient for next time wearing.
5. Storage conditions: low temperature, dry, and dark.