Working principle and debugging method of anti-static wrist strap online monitor
The Wrist Strap Online Monitor is mainly used to monitor the working condition of the wristband worn by the staff and to monitor the wrist strap continuously. It is mainly affected by the static resistance of the staff's own body resistance and the working environment (anti-static floor, anti-static shoes, work clothes, table mats, chairs, etc.), and the fine-tuning is adjusted to make it work normally.
The wrist strap online monitor has a maximum measurement resistance of 2M. Do not insert the wrist strap, directly connect the ground wire, adjust the fine adjustment to the left, you can not consider the green light when the air is displayed, because the body's own body resistance impedance is about 1M, the impedance of the wrist strap is 1M ± 5%, other static electricity The impedance brought by the measure will not be greater than 1M.
The minimum measurement resistance of the anti-static wrist strap online monitor is 800K±10% ohm. The detection method is as follows: adjust the fine adjustment of the online monitor to the rightmost end, connect the ground wire and the power supply, the red light flashes, and accompanied by an alarm sound, connect one end of the adjustable resistance tester to the ground wire, and the other end and the wrist. With the jack connection, then slowly slide the adjuster so that its red light turns green and the alarm sound disappears. The resulting resistance is the minimum range of the online monitor.
In the normal working situation, the staff wears a wrist strap to adjust the fine adjustment, and adjusts the fine adjustment when the red light turns into the green light's critical point, and the adjustment is completed. If there is a problem with this instrument, the fine adjustment will be out of control when the fine adjustment is adjusted, and it will not work normally.