Ion fan removes static electricity
The use of an ion fan can achieve the effect of static elimination. The ion fan uses more clean room antistatic materials. In the past, the head drive industry used ESD control technology only in the production of ICs (chips, microchips). But now more industries have adopted ESD control technology.
Because of the impact of electrostatic discharge (ESD) on precision circuits and disks, the electronics industry faces enormous challenges. They will lose billions of dollars each year. A voltage of only 5V can damage tiny components, and voltages less than 100V can cause the entire electronic circuit to be scrapped.
ESD control data is also prone to pollution - ion fan static dissipative materials are a major source of dust particles and chemical contamination in cleanrooms. To control the ESD, however. Items in the clean room are made up of static dissipative materials that block ESD and electrostatic attraction. Choosing an anti-static ion blower for a clean room is a big challenge. ESD solutions are more complex than finding static dissipative data. Therefore, experts recommend a set of ESD control sequences.
Finding the right antistatic raw materials is difficult. The ion fan mask is made of plastic. Low volatiles and chemical resistance, good information for clean rooms. Finding very transparent raw materials is difficult. Additives and copolymers make the data opaque due to the composition of different refractive indices. Plastics must have good surface resistance. Electrostatic sensitivity is also increasing. In the past three years, manufacturers of ESD products have had difficulty in developing new types of static dissipative materials. The IC becomes smaller. Many electronics manufacturers are also beginning to demand more ion fan ESD products. Manufacturers provide products for use in cleanrooms, recognizing the need for ESD products in cleanrooms. But finding an ESD product that can be used in a clean room is a problem. Because the performance of many ESD products used in clean rooms is not stable enough. The biggest problem with ESD control in cleanrooms is the movement of people in cleanrooms.
0
top